While the Chaser Ch-e80 is not a household name, the installation and troubleshooting principles below apply to virtually any label or receipt printer. This guide will help you get your Ch-e80 up and running as quickly as possible.
Once installed, you may need to tweak the driver settings for your specific workflow.
Installing the Chaser Ch-e80 is a straightforward process, provided you follow the correct sequence of powering on the hardware and installing the software. Step 1: Download the Correct Driver Chaser Ch-e80 Print Driver
Need to get your up and running? We’ve got you covered.
Right-click the newly installed (or POS80 ) icon and select Printer Properties . Optimizing Key Settings While the Chaser Ch-e80 is not a household
This happens due to a driver mismatch or incorrect baud rate settings on Serial connections. Ensure you installed the 80mm driver instead of a 58mm driver, and verify that the emulation mode matches your POS software. Issue 3: Printer prints too slowly
Place a fresh 80mm thermal paper roll into the chamber to run test prints later. Installing the Chaser Ch-e80 is a straightforward process,
Go to your computer’s system settings (e.g., on Windows).
Open Printing Preferences , locate the Advanced or Halftone settings, and increase the print density or heating time. Note that higher density settings slightly reduce maximum print speed. Operating System Compatibility
Open a web browser and type http://localhost:631/ to access the CUPS interface. Click > Add Printer .