| Controller Terminal | Connects To | | :--- | :--- | | | Power adapter (12V DC) | | NO / COM | Electric lock (Normally Open) | | NC / COM | Electric lock (Normally Closed) | | PUSH | Exit button (momentary switch) | | D-IN | Door contact/magnetic sensor |
Incorrect wiring is the #1 cause of V2000-c failure. Refer to the pinout diagram (usually on the rear of the device).
Ensure the card type (EM vs IC) matches the reader frequency and that there is no metal interference behind the mounting surface.
For security purposes, change the factory default master code immediately. Enter Programming Mode ( * 9999 # ). Press 0 . Enter your + # . Re-enter the New Master Code + # . Exit Programming Mode ( * ). Adding User Cards / Key Fobs
To perform any administrative task, you must first enter the system's programming mode.
To modify settings, you must enter Programming Mode. While in this mode, the indicator light changes color (typically flashing orange or red).
A proper wiring configuration prevents premature hardware failure and secures against bypass methods. Ensure the system power supply is completely disconnected before wiring the terminals. Terminal Label Function Description Connection Target 12V Positive DC Input Power Supply Positive (+) GND Ground/Negative Power Supply Negative (-) NC Normally Closed Relay Positive terminal of Fail-Safe Lock (Magnetic Lock) NO Normally Open Relay Positive terminal of Fail-Secure Lock (Electric Strike) COM Common Relay Terminal
The V2000-C is a widely used, standalone RFID access control keypad designed for secure and reliable entry management. This comprehensive guide serves as an extended user manual, detailing the technical specifications, wiring configurations, and step-by-step programming instructions for the device. 1. Product Overview and Technical Specifications
Even with perfect installation, issues occur. Refer to this matrix.