Lenel Lnl3300m5 — Installation Manual Upd Top !!link!!

If the LNL-3300-M5 is the physical first or last device on the RS-485 bus, install a 120-ohm resistor across the data lines or activate the onboard termination jumper. Hardware Configuration (DIP Switches)

4.56 in. W x 10.25 in. L x 0.8 in. H (115.8 mm x 260.4 mm x 20.3 mm). Required Cable Specifications

Weeks later, when a power surge tripped the main breaker during a storm, the upgraded controllers recovered gracefully. The manual’s instructions about power sequencing and termination proved worth their weight in calm, methodical resets. The labs stayed locked where they needed to be; alarms behaved, and staff clocked in on time.

Connect the labeled reader, input, and output wires to the corresponding terminals on the LNL-3300-M5. lenel lnl3300m5 installation manual upd top

Assign the target static IP address, subnet mask, and default gateway authorized by the network administrator.

Supports up to 32 board addresses and can store up to 50,000 events in non-volatile memory. Communication:

15 MB onboard flash memory for database and event storage. Panel Layout and Components If the LNL-3300-M5 is the physical first or

Before beginning the installation, ensure the hardware environment meets the following specifications: LenelS2 OnGuard system software.

Lenel typically provides manuals through their partner portal. If you’re a certified integrator, check the “Product Documentation” section for the latest revision of the LNL-3300M5 installation guide (DOC# LNL-3300M5-INST-xx).

Disconnect the wiring harnesses and mounting screws from the old legacy controller. and 4 OFF

15 MB of available on-board memory for database storage.

is part of the Series 3 intelligent controller lineup. It is designed to be highly flexible, offering onboard reader ports, input/output points, and support for additional downstream modules (like LNL-1320, LNL-1100, etc.). Capacity: Supports up to 240,000 cardholders. Networking: Native 10/100 Ethernet communication. Downstream Support: Supports up to 32 downstream devices.

: Set DIP switch 1 OFF , 2 ON , 3 OFF , and 4 OFF , then cycle power.

The onboard LEDs provide real-time diagnostic information regarding the health and connectivity of the panel.