A: Yes. The iPROG+ Pro and newer iPROG+ versions support all common serial EEPROM families, including 24Cxx, 25Cxx, 93Cxx, 95Cxx, 35080, 7002MN010, 77007, ERxx, M6M80021, and many others. Additionally, the SMART EEPROM adapter supports chips such as MW 93C46, 93C56, 93C66, 93C76, 93C86, and I²C 24C00/24LC00/24C01/24C02/24C08/24C16/24C32/24C64/24 128/24256/24512, among others.
The "portable" aspect of the iProg system refers to its ability to perform high-speed chip reading and writing in varied environments, such as a garage or on-site vehicle repair.
: The software allows you to toggle between different voltage levels (e.g., 2.6V, 2.8V, 3.3V, 5V) depending on the specific EEPROM chip's requirements (such as the 35080 or 24C series). Supported Chip Types iprog eeprom adapter pinout portable
🛠️ Many low-cost aftermarket "clones" suffer from hardware defects where the software yields a "device error" on all EEPROMs. This is typically a physical trace or resistor issue on the green adapter board itself that requires manual soldering to bridge correct pins.
Cause: Incorrect pinout orientation or back-powering issues from the host PCB. A: Yes
A cable that rolls up in a ziploc bag. No clunky adapter PCB. You can read a laptop BIOS chip in a parking lot.
You are on site. The dashboard is pulled. You connect your iProg, but the software says "No device found" or "Chip ID mismatch." Here is the portable troubleshooting checklist based on pinouts: The "portable" aspect of the iProg system refers
| Pin Number | Signal Name | Primary Protocol | EEPROM Function | | :--- | :--- | :--- | :--- | | 1 | VCC (5V/3.3V) | Power | Chip Power Supply | | 2 | GND | Ground | Common Ground | | 3 | SCL / CLK | I2C / SPI | Clock Line | | 4 | SDA (MOSI) | I2C / SPI | Data / Master Out Slave In | | 5 | MISO | SPI | Master In Slave Out | | 6 | CS / CE | SPI / Microwire | Chip Select | | 7 | AUX / OE | GPIO | Output Enable (Rarely used for EEPROM) | | 8 | RESET | uC Programming | Reset Line (for MCUs, not basic EEPROM) | | 9 | VPP (12V) | High Voltage | Programming Voltage (for old EPROMs) | | 10 | GND | Ground | Extra Ground |