Achi Ir6500 Software Hot -
Temperature (°C) 220-240°C | /-----\ (Reflow / Peak) | / \ 150-180°C | /---------------/ \ | / (Soak / Flux Activation) \ | /------------/ \ | / (Preheating) \ |_/_______________________________________________\___ Time 1. Preheating Stage 100°C to 120°C Purpose: Drives moisture out of the PCB substrate gently.
: While the hardware controller is limited to 10 programs of 8 steps each, the software allows for virtually unlimited profiles with more than 8 steps for complex soldering tasks .
: The software is generally free for device owners and does not require complex driver installation on many modern systems. set up a specific temperature profile for lead-free BGA rework using this software? #95 | IR6500 Rework Station Software (PC410 Controller) achi ir6500 software hot
Beyond the raw specs, several thoughtful design choices set the IR6500 apart:
| Industry | Fault Type | Thermal Signature in Software | | :--- | :--- | :--- | | | Loose connection | A single terminal 30°C+ hotter than others | | Mechanical | Bearing failure | Friction heat along a rotating shaft | | Building | Air leakage | Cold (blue) streaks in winter; Hot (red) in summer | | HVAC | Compressor short-cycling | Rapid temperature spikes every few minutes | Temperature (°C) 220-240°C | /-----\ (Reflow / Peak)
Temperature (°C) ^ 230 | /--- Peak (230°C - 245°C) | / \ 180 | /-------------/ \ | / Soak Phase \ 150 | / (150°C-180°C) \ | /-----/ \ | / Preheat \ Cooling | / Phase \ Phase +----------------------------------------------------> Time
Controlled cooling prevents structural fracturing inside the joint matrix. Step-by-Step Software Setup and Connection Guide : The software is generally free for device
| | User Reports / Considerations | | :--- | :--- | | Difficulty of Use | The software lacks an intuitive interface, requiring significant time and experimentation to master. | | Communication Issues | The USB port on the station is Type A (host) rather than the standard Type B, requiring a specific and less common cable. | | Virus Scare | Antivirus software (e.g., McAfee) has flagged the software's setup.exe as a virus. The general advice is to install it on an isolated, non-critical PC. | | Driver and OS Issues | Drivers for both 32-bit and 64-bit operating systems are included, but users still report problems with Windows 10. | | Alternative Software | Some users have turned to alternative software like PSoft when the original software has issues. |
After installation, you will see a small thermometer icon in the system tray. Clicking it reveals:
